£400 + VAT per working drive, any CCTV recorderSend the drive, not the recorder · 5 working days · paid upfrontSwitch it off, then call:0800 6890668
CCTV·DRCCTV Data Recovery 0800 6890668 Send a drive
CCTV·DR / Who needs it / CCTV installers and alarm companies

Call-out · HDD error · customer needs footage · do not init · swap the drive · bag and label the old one · flat fee per drive · £400 + VAT

CCTV installers and alarm companies. You are usually first on the scene. What you do in the first ten minutes decides whether there is anything to recover.

An engineer's job on a call-out is to get the system working, and the quickest way to do that with a disk fault is to initialise the drive. On most visits that is the right call, because nobody needs last month's footage. On the visit where the customer says 'we had a break-in on Tuesday', it is the wrong one, and the engineer is the person who will be asked about it afterwards. This page is a short procedure for that visit: how to leave the customer with a recording system and an untouched drive, and where the drive goes next.

Binary image first, original untouchedAll video processed from the imageDrive only, not the recorder£400 + VAT per working drive, paid upfront

Switch the recorder off first. Then tell us the make, what happened and the date you need: we say what is realistic before you pay anything
0800 6890668

What can and cannot come back.

Can be recoveredThe customer's footage, from a drive you left alone
FromA binary image and processing of the video in the recorder's own format
Cannot be recoveredA drive that was initialised and left recording for a week

The situations that come up.

SituationWhat is usually wantedWhat the drive can giveWorth knowing
HDD error, customer needs footageThe footageUsually up to the start of the errorSwap the drive; do not init
Uninitialized after a power cutThe footageUsually all of itDecline the prompt
Recorder dead, replacing the unitThe footage on the old driveUsually all of itNew recorder gets a new drive
You have already initialised itThe footageOften most, if powered off nowSay so; note the time
RAID or multi-bay recorderThe array£400 + VAT per driveNumber every drive by bay; do not rebuild
Customer only wants it workingNothingn/aInitialise away

What to do.

  1. Ask the question before opening the menuWhether anything recorded is needed. Write the answer on the job sheet.
  2. Photograph the screenThe error and the HDD status page as you found them.
  3. Power down and pull the driveAnti-static bag, label, and hand it to the customer or take it with a signed note.
  4. Fit and initialise a new driveCheck recording on all channels, and that overwrite and the disk-error alarm are on.
  5. Point the customer hereOr send the drive in for them. The form asks who the footage belongs to and where it should be returned.

Particular to you

  • Things that look like fixes. Rebuilding the database, repairing the disk from the maintenance menu, upgrading firmware 'in case it helps', trying the drive in your test recorder. Each can write to the drive. If footage is wanted, none of them is worth trying on site.
  • RAID. Do not rebuild, re-create or re-initialise an array that holds wanted footage, and do not pull drives without numbering them by bay. Hikvision's own FAQ notes that its RAID modes require enterprise-class drives; arrays built on anything else fail in untidy ways. Multi-drive jobs are charged at £400 + VAT per drive.
  • Your position. This service deals with the drive and answers to whoever instructs it. It does not comment on installations or on what an engineer did, beyond stating what the drive shows. No trade referral fee is paid and none is asked for.

In more detail.

Why 'init' is the reflex, and when to resist it

Every maker's troubleshooting route for a disk fault ends in the same place. Hikvision: 'If the status remains then format the HDD.' Dahua: 'Format HDD.' Reolink: 'format the HDD again.' The advice is written for getting a recorder recording, and it works. It is silent about the recordings because the makers' concern is the product. An engineer following the book is doing nothing wrong by the book. The customer who needed Tuesday's footage will see it differently, which is reason enough to ask the question first and write down the answer.

What we need from you

The drive, untouched, and four facts: the recorder's make and model, which bay the drive was in, what the screen said, and anything that was done to it. If a format or initialise has already happened, the time it was done and the time the recorder was powered off matter more than anything else, because together they define how much has been recorded over. Brand matters too: the published formats are well understood, and budget or unbranded recorders vary, so the model number from the label saves time.

What your customer gets

All the footage that can be recovered, as ordinary video files by channel and time, with the results by email. Up to 100 GB is delivered by a free download link; a backup to an external drive is an extra cost. Turnaround is 5 working days from the drive and payment arriving. A failing drive takes longer and costs more than the standard fee, which is for a working drive. Fees are not refunded if the footage proves to have been overwritten or never recorded. It is kinder to tell the customer that on site than for them to learn it from the invoice.

Sources
  1. Hikvision USA support, 'Audible Warning is saying there is a HDD error' — supportusa.hikvision.com/support/solutions/articles/17000128918-audible-warning-is-saying-there-is-a-hdd-error
  2. Dahua Wiki, Troubleshoot: No HDD — dahuawiki.com/Troubleshoot/NVR/No_HDD
  3. Reolink support, 'Reolink HDD Cannot Be Formatted' — support.reolink.com/articles/900002167226-Reolink-HDD-Cannot-Be-Formatted/
  4. Hikvision video recorders FAQ (mirrored by DVRAID): RAID needs enterprise drives — www.dvraid.com/how-to/hikvision-video-recorders-faq/
  5. Hikvision USA support, 'What do I do after I install a new hard drive?' — supportusa.hikvision.com/support/solutions/articles/17000129501-what-do-i-do-after-i-install-a-new-hard-drive-

Quotations were checked against the sources listed in November 2026. Makers change their support pages and manuals; follow the links for the current wording. Research figures are the authors' results on their own drives. No maker, regulator or police body listed is connected with this site.

Asked by cctv installers and alarm companies.

I have already initialised the drive. Is it too late?

Usually not, if the recorder is powered off now. Note the times and send the drive.

Is there a trade price?

No. One flat fee of £400 + VAT per drive, whoever sends it, paid upfront and non-refundable.

Can I send the whole recorder?

No. The drive only. Whole recorders are taken only in exceptional circumstances, and removing the drive is charged extra.

Switched off. Drive out. Then tell us what happened.

Tell us the recorder, what happened and the date you need. The reply, inside a working day, says whether the footage is likely to be on the drive. Nothing is charged for that. Recovery is £400 + VAT per working drive, paid upfront and non-refundable; failing or damaged drives cost more and are quoted first.