£400 + VAT per working drive, any CCTV recorderSend the drive, not the recorder · 5 working days · paid upfrontSwitch it off, then call:0800 6890668
CCTV·DRCCTV Data Recovery 0800 6890668 Send a drive
CCTV·DR / The recorder said / Nothing: the recorder is dead

No lights · no picture · stuck on the start-up logo · restarts in a loop · power adapter · the footage is on the drive · do not fit it in the new recorder · £400 + VAT

Nothing: the recorder is dead. Of all the ways to lose access to footage, this is the kindest. The recordings are on the drive, and the drive is usually fine.

Recorders fail. Power adapters are the weakest part, followed by the capacitors on the main board, followed by damage from lightning and surges through the camera cables. The owner is left with a box that does nothing, or one that reaches its logo and goes no further. If the fault is in the recorder and not the drive, nothing has happened to the recordings. They stopped being added to when the recorder died, and they will stay exactly as they are until something writes to the drive. The thing most likely to write to it is a replacement recorder, which will not recognise the old drive's contents and will offer to initialise it.

Binary image first, original untouchedAll video processed from the imageDrive only, not the recorder£400 + VAT per working drive, paid upfront

Switch the recorder off first. Then tell us the make, what happened and the date you need: we say what is realistic before you pay anything
0800 6890668

ON SCREEN● ALARM
(no display)
Typical wording; yours may differNo message: the recorder shows nothing, stops at its start-up logo, or restarts repeatedly

What can and cannot come back.

Can be recoveredEverything on the drive up to the moment the recorder died
FromA binary image of a drive that is, most often, undamaged
Cannot be recoveredFootage from after the recorder stopped

Why it says that.

The third column is the question that matters most: if the recorder stopped recording when the message began, nothing after that point exists.

Likely causeHow to tellWas it still recording?What the bench does
Dead power adapterNo lights at allNo, since it diedDrive healthy; read in full
Main board failureLights, fan, no pictureNoDrive healthy; read in full
Stuck on logo or restartingOften the drive stalling the start-upProbably notDrive may be failing; imaged with care
Surge or lightningFailed during a storm; other equipment affectedNoDrive's electronics may also be damaged
Firmware update failedDied during an updateNoDrive unaffected by the update
Replacement recorder fitted with old driveNew unit asked to formatDepends on the answer givenIf declined, drive intact

What to do, in order.

  1. Check the obviousIs the adapter's light on? Is the socket live? A matching adapter of the same voltage and at least the same current is a fair test.
  2. If it restarts in a loop, stopRepeated start-ups work a struggling drive hard.
  3. Remove the driveBefore the recorder goes for repair, to the tip or back to the supplier.
  4. Keep the drive out of the replacementFit a new drive in the new recorder.
  5. Note when it diedThe last time anyone saw it working. Footage exists up to about then.

Do not

  • Do not fit the old drive in a new or borrowed recorder.
  • Do not send the recorder for warranty replacement with the drive inside.
  • Do not use an adapter of a different voltage.
  • Do not let a repairer 'reset' the unit with your drive in it.
  • Do not throw the dead recorder away before taking the drive out.

The message, in more detail.

The recordings are not in the recorder

A recorder is a small computer whose job is to receive video from the cameras and write it to a hard drive. All the footage is on that drive. The recorder's own memory holds its settings and nothing else. When the recorder fails, the drive simply stops receiving new video. People sometimes assume that a dead recorder means lost footage, or that the recorder must be repaired before anything can be recovered. Neither is so. The drive is read by other means, and the recorder is not needed, not for its password, its settings or its format.

The replacement recorder

The natural repair is a new recorder, and the natural economy is to reuse the old hard drive. A recorder shown a drive it did not format itself, even from the same maker, will usually report it as uninitialised and ask to initialise it; one maker's own article says of a newly fitted drive that the unit 'should ask to initialize the drive, select yes/ok'. An installer working quickly will press yes. Buy a new drive with the new recorder. If the footage on the old one is not needed, it can be reused later. If it is, the drive should never be in a recorder again until it has been imaged.

When the drive is the reason

A recorder that hangs on its logo or restarts endlessly is sometimes being stopped by its drive. At start-up the recorder waits for the drive to report ready; a drive with failing heads may never do so, or may do so and then stall. Unplugging the drive's data lead and powering on is a fair test: if the recorder now starts and reports 'No HDD', the recorder is sound and the drive is the fault. That changes the recovery from the easiest kind to one that depends on how much of the drive can be read.

Sources
  1. Hikvision USA support, 'What do I do after I install a new hard drive?' — supportusa.hikvision.com/support/solutions/articles/17000129501-what-do-i-do-after-i-install-a-new-hard-drive-
  2. Han, Jeong and Lee, 'Analysis of the HIKVISION DVR File System', ICDF2C 2015 (Springer LNICST) — eudl.eu/pdf/10.1007/978-3-319-25512-5_13
  3. SWGDE Best Practices for Computer Forensic Acquisitions v2.0 (image types, hashing, records to keep) — www.swgde.org/wp-content/uploads/2024/03/2023-06-15-SWGDE-Best-Practices-for-Computer-Forensic-Acquisitions-17-F-002-2.0.pdf
  4. Western Digital, WD Purple surveillance hard drives — www.westerndigital.com/en-sg/products/internal-drives/wd-purple-sata-hdd
  5. ACPO Good Practice Guide for Digital Evidence, Version 5 (the four principles; handling a computer found on or off) — training-on-eppo.era.int/EPPO/kiosk/pdf/ACPO_Good_Practice_Guide.pdf

Quotations were checked against the sources listed in November 2026. Makers change their support pages and manuals; follow the links for the current wording. Research figures are the authors' results on their own drives. No maker, regulator or police body listed is connected with this site.

Asked about this message.

The recorder is dead. Is the footage lost?

No. It is on the hard drive, which is usually unaffected.

Do you need the recorder to read the drive?

No. Send only the drive.

What does it cost?

£400 + VAT for one drive, paid upfront and non-refundable.

Switched off. Drive out. Then tell us what happened.

Tell us the recorder, what happened and the date you need. The reply, inside a working day, says whether the footage is likely to be on the drive. Nothing is charged for that. Recovery is £400 + VAT per working drive, paid upfront and non-refundable; failing or damaged drives cost more and are quoted first.