£400 + VAT per working drive, any CCTV recorderSend the drive, not the recorder · 5 working days · paid upfrontSwitch it off, then call:0800 6890668
CCTV·DRCCTV Data Recovery 0800 6890668 Send a drive
CCTV·DR / The recorder said / 'HDD not formatted'

HDD not formatted · format failed · 'format the HDD again' · restart loop · after a power cut · structures damaged, video present · £400 + VAT

'HDD not formatted'. It was formatted, and it was full of recordings. What has gone is the recorder's ability to read its own filing.

This message appears on the storage or playback screen of NVRs, Reolink's among them, when the recorder checks its drive and does not find the file structures it expects. It reads like a statement about a new disk. On a drive that has been recording for a year, it means something has damaged those structures: a power cut in mid-write, unreadable sectors, or the early stages of drive failure. The recordings sit behind the damage. Reolink's support page for the fault offers its fix in one sentence, 'Restart the NVR and then format the HDD again', and a recorder obediently formatted will work again with nothing on it.

Binary image first, original untouchedAll video processed from the imageDrive only, not the recorder£400 + VAT per working drive, paid upfront

Switch the recorder off first. Then tell us the make, what happened and the date you need: we say what is realistic before you pay anything
0800 6890668

ON SCREEN● ALARM
HDD not formatted
Quoted from the makerReolink support: "The HDD status or playback interface shows 'HDD not formatted'"

What can and cannot come back.

Can be recoveredRecordings behind damaged file structures
FromA binary image on which the structures are repaired or bypassed
Cannot be recoveredRecordings overwritten after a successful re-format

Why it says that.

The third column is the question that matters most: if the recorder stopped recording when the message began, nothing after that point exists.

Likely causeHow to tellWas it still recording?What the bench does
Power cut mid-writeMessage appeared after a cutNo, until re-formattedStructures repaired on the image
Bad sectorsNVR slow or restartingNoImaged with error handling; files located by content
Format attempted and failed'Format failed' or the message returnsNoUsually a failing drive; imaged carefully
Format attempted and succeededMessage gone, playback emptyYes, sinceOld recordings searched for; some may be overwritten
Drive failing outrightClicks, or NVR will not start with it fittedNoHardware imaging; may be partial
Drive swapped between NVRsMessage on the second NVRNoShould be intact if nothing was accepted

What to do, in order.

  1. Do not format againWhatever the screen or the support page says.
  2. Stop restarting itEach start-up makes the drive work through the same damaged area.
  3. Power off and remove the driveNote the message and when it first appeared.
  4. Secure any second copyIf cameras have their own SD cards, take them out and keep them.
  5. Fit a new drive if you need the system runningFormat the new one. Keep the old one untouched.

Do not

  • Do not 'format the HDD again'.
  • Do not let the NVR keep restarting.
  • Do not connect the drive to a PC and run a repair tool on it.
  • Do not leave camera SD cards recording over the incident.
  • Do not send the NVR.

The message, in more detail.

Structures and contents

A recorder that uses a conventional file system keeps two kinds of information on its drive: the recordings, which occupy almost all of it, and a small set of tables that say where each recording is. The tables are rewritten constantly as recording proceeds, so they are what is being written when the power fails. Damage a few sectors of tables and the whole drive becomes unreadable to the recorder, though every recording is physically intact. On a copy of the drive those tables can be repaired, or the recordings found without them.

Why repair is done on the image

Repair tools change what they repair. Run on the original drive, a file-system repair that guesses wrong can link recordings to the wrong places or mark them as free space, and there is no way back. That is why the first act is always a binary image: a sector-for-sector copy of the drive with nothing interpreted and nothing altered. Every repair, every search, every attempt to open the recordings is then made on the image. If one approach fails, another can be tried on a fresh copy of it. The drive itself is read once.

If the format went through

Many people reach this page after doing what the support article said. If the format failed, the drive has probably deteriorated further but nothing new was written, and the position is unchanged. If the format succeeded, the old tables have been replaced with empty ones and the NVR has started recording again. The old recordings are still largely there at first and are searched for by their content. As everywhere on this site, the amount recoverable falls with each hour the recorder is left running, and what has been recorded over cannot be brought back.

Sources
  1. Reolink support, 'Reolink HDD Cannot Be Formatted' — support.reolink.com/articles/900002167226-Reolink-HDD-Cannot-Be-Formatted/
  2. Reolink support, 'NVR HDD is Full And Cannot Overwrite' — support.reolink.com/hc/en-us/articles/900002131203-NVR-HDD-is-Full-And-Cannot-Overwrite/
  3. SWGDE Best Practices for Computer Forensic Acquisitions v2.0 (image types, hashing, records to keep) — www.swgde.org/wp-content/uploads/2024/03/2023-06-15-SWGDE-Best-Practices-for-Computer-Forensic-Acquisitions-17-F-002-2.0.pdf
  4. ACPO Good Practice Guide for Digital Evidence, Version 5 (the four principles; handling a computer found on or off) — training-on-eppo.era.int/EPPO/kiosk/pdf/ACPO_Good_Practice_Guide.pdf
  5. Yang, Li and Wu, 'Basic Principle and Application of Video Recovery Software for Dahua and Hikvision Brand', SHS Web of Conferences 14 (2015) — doaj.org/article/70994b3b90834c3689cabf8815611700

Quotations were checked against the sources listed in November 2026. Makers change their support pages and manuals; follow the links for the current wording. Research figures are the authors' results on their own drives. No maker, regulator or police body listed is connected with this site.

Asked about this message.

Support told me to format again. I have. Now what?

Switch the recorder off. If the format worked, it is recording over the old footage. If it failed, the drive is probably failing. Either way, remove it.

Can I run a disk repair on it myself?

Not on the original. A repair that goes wrong cannot be undone. Repairs are made on a copy.

What does it cost?

£400 + VAT for one drive, paid upfront and non-refundable.

Switched off. Drive out. Then tell us what happened.

Tell us the recorder, what happened and the date you need. The reply, inside a working day, says whether the footage is likely to be on the drive. Nothing is charged for that. Recovery is £400 + VAT per working drive, paid upfront and non-refundable; failing or damaged drives cost more and are quoted first.