No HDD · No HDD is detected · no disk found · System can not detect hard disk · cable, power or the drive itself · £400 + VAT
'No HDD' or 'no disk found'. The recorder cannot see a drive at all. The footage up to that moment is still on it, if the drive can be read.
'No HDD' is a different message from 'HDD Error'. The recorder is not failing to write; it cannot find a drive to write to. There are three ordinary reasons. A lead has come off. The recorder's power supply has weakened and can no longer spin the drive up. Or the drive itself has died: its motor, its heads or its electronics. In all three the recorder has recorded nothing since the drive vanished. The makers' advice starts sensibly, with cables, and then goes wrong. Dahua's troubleshooting list for 'No HDD' reads: 'Format HDD. If you cannot format HDD from device, format HDD from a PC.'
Switch the recorder off first. Then tell us the make, what happened and the date you need: we say what is realistic before you pay anything
0800 6890668
No HDD is detected
What can and cannot come back.
Why it says that.
The third column is the question that matters most: if the recorder stopped recording when the message began, nothing after that point exists.
| Likely cause | How to tell | Was it still recording? | What the bench does |
|---|---|---|---|
| Lead off | Recorder was moved; drive spins quietly when powered | No, while detached | Healthy drive, read in full |
| Weak power adapter | Drive tries to spin and stops; recorder restarts | No | Drive powered properly and imaged |
| Drive electronics failed | Drive silent and cold | No | Board-level work to get it reading, then imaged |
| Heads or motor failed | Clicking, buzzing or beeping from the drive | No | Imaged on hardware for failing drives; may be partial |
| Recorder's SATA port failed | A known-good drive is not seen either | No | Drive is fine; read in full |
| Drive was never there | New owner, never checked | Never | Nothing to recover |
What to do, in order.
- Switch off at the wallDo not work inside a powered recorder.
- Check the leads onceTwo leads go to the drive: a flat data lead and a power lead. Push each home at both ends. Do not swap in other parts.
- Power on and listenA healthy drive spins up with a soft whirr within seconds. Clicking, repeated attempts or silence are all bad signs.
- If it is still 'No HDD', stopPower off. Further attempts do not help a failing drive.
- Take the drive out and note the dateRecord when the message was first seen. Nothing after that date was recorded.
Do not
- Do not format the drive from a PC, though the maker's wiki suggests it.
- Do not keep cycling the power to 'wake' the drive.
- Do not tap, shake or freeze the drive.
- Do not open the drive's own casing.
- Do not fit a new drive and bin the old one.
The message, in more detail.
Three causes, one test
Reseating the leads, once, with the power off, separates the cheap cause from the others. If the message clears, the drive was merely disconnected and the only loss is the period it was off. If it does not clear, listen. A drive that spins and stays spinning but is not detected points to the recorder or the drive's electronics. A drive that clicks rhythmically, or spins up and down, has a mechanical fault. A silent drive has usually lost its electronics or its motor. Report what you heard; it tells the bench how to approach the first power-up, which on a failing drive may be one of few.
'Format HDD from a PC'
Dahua's wiki page for this message lists steps to try: reboot, check cables, 'Format HDD. If you cannot format HDD from device, format HDD from a PC', then replace. For a blank replacement disk that advice is harmless. For the drive holding your recordings it is the worst option on the list. A PC format writes a Windows file system over the start of a disk laid out in the recorder's own format, damaging the very structures that say where each camera's video is. It also does nothing for a drive the recorder could not detect in the first place.
What can be read from a drive a recorder cannot see
A recorder gives up quickly. It asks the drive to identify itself, waits a few seconds, and reports 'No HDD'. Laboratory imaging equipment is more patient and more capable: it can supply clean power, control how the drive starts, read with some heads and not others, and skip damaged regions and return to them. Many drives that a recorder cannot see can be imaged completely or nearly so. Some cannot be read at all. The standard fee is for a working drive. One that needs electronic or mechanical work before it can be imaged takes longer and costs more, and you are quoted the extra cost first and decide whether to go ahead. Fees are not refunded if the drive proves unreadable.
- Hikvision USA support, 'Audible Warning is saying there is a HDD error' — supportusa.hikvision.com/support/solutions/articles/17000128918-audible-warning-is-saying-there-is-a-hdd-error
- Dahua Wiki, Troubleshoot: No HDD — dahuawiki.com/Troubleshoot/NVR/No_HDD
- Lorex, RD101 series DVR FAQ and troubleshooting guide — www.lorex.com/blogs/help/rd101-series-1080p-8-channel-digital-video-recorder-faq-troubleshooting-guide
- SWGDE Best Practices for Computer Forensic Acquisitions v2.0 (image types, hashing, records to keep) — www.swgde.org/wp-content/uploads/2024/03/2023-06-15-SWGDE-Best-Practices-for-Computer-Forensic-Acquisitions-17-F-002-2.0.pdf
- Yang, Li and Wu, 'Basic Principle and Application of Video Recovery Software for Dahua and Hikvision Brand', SHS Web of Conferences 14 (2015) — doaj.org/article/70994b3b90834c3689cabf8815611700
Quotations were checked against the sources listed in November 2026. Makers change their support pages and manuals; follow the links for the current wording. Research figures are the authors' results on their own drives. No maker, regulator or police body listed is connected with this site.
Asked about this message.
The recorder cannot see the drive. Can you?
Often. Laboratory equipment can read drives a recorder gives up on. Not always. A faulty drive costs more than the standard fee, and fees are non-refundable.
Should I try the drive in a computer?
No. Windows will not recognise the format and will offer to initialise it, which damages it.
What does it cost?
£400 + VAT for a working drive, paid upfront and non-refundable. If the drive itself has failed, it takes longer and costs more, quoted first.
Switched off. Drive out. Then tell us what happened.
Tell us the recorder, what happened and the date you need. The reply, inside a working day, says whether the footage is likely to be on the drive. Nothing is charged for that. Recovery is £400 + VAT per working drive, paid upfront and non-refundable; failing or damaged drives cost more and are quoted first.